Audio Pro LV-SUB Owner's Manual page 10

JOin eXisting audiO prO netwOrk
if you already have one of audio pro's wireless lv loudspeakers and a tX100 wireless transmitter,
the lv-suB automatically connects to your network. simply set the same house Code and zone
that your existing lv loudspeakers use and connect the lv-suB to the power socket.
COnneCting the lv-suB tO an eXisting netwOrk FOr the First time:
in order to synchronise volume levels so that the lv-suB plays at the same level as other
loudspeakers in the same zone and house Code:
1. ensure that all the loudspeakers in the zone (a, B or C), including the lv-suB, are switched on
and set to the same zone and house Code (all lv loudspeakers are set to zone aas default).
2. set the level on the rear of the lv-suB to the middle position (0).
3. raise or lower the volume using the remote control's zone volume: a, B or C.
(point the remote control at the receiving loudspeaker, e.g. lv-2 loudspeaker)
4. the volume levels for all units in the zone should now be synchronised.
if you do not synchronise the levels, the lv-suB may emit too little or too much bass.
(you can manually raise or lower the bass volume if you desire more or less bass.
the controls for this can be found on the rear of the lv-suB.)
note:
- the lv-suB volume is controlled in the network using the same remote control as for audio pro's
wireless lv loudspeakers.
- manual default settings, such as subwoofer volume and crossover frequency, can be found on the
rear of the lv-suB.
analOgue COnneCtiOn tO the stereO/reCeiver
you can create an analogue connection from the lv-suB to any stereo/receiver equipped with a
sub-output. Connect with a cable from the sub-output to the line in on the rear of the lv-suB
note: if LV-sUB is connected by cable, it will be excluded from wireless network.
10