1. Manuals
  2. Brands
  3. Wohler Manuals
  4. Data Loggers
  5. CDL 210
  6. Operating manual

Wohler CDL 210 Operating Manual

Co2 logger
Hide thumbs Also See for CDL 210:
Table of Contents

Advertisement

Quick Links

Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CDL 210 and is the answer not in the manual?

Questions and answers

Related Manuals for Wohler CDL 210

Summary of Contents for Wohler CDL 210

  • Page 1 Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 TestEquipmentDepot.com...

  • Page 3: Table Of Contents

    Contents 7 .8 Reset ............50 Sampling Rate ..........51 -Calibration ........51 Automatic Baseline Calibration ....52 Manual Calibration ........52 Trouble shooting ........ 53 Error Code ........... 53 10.1 C02-Werte ........... 53 10.2 Air Temperature Readings ......54 10.3 Air Humidity Reading ........
  • Page 5 Adresse Wohler Technik GmbH Schi.itzenstr. 41 33181 Bad Wi.innenberg Tel.: +49 2953 73-100 Fax: +49 2953 73-250 E-Mail: info@woehler.de...
  • Page 8 COrConcentration CO2-concentration in the Recomendations < 700 ppm Good optimal (Display Wohler CDL 210) No further ventilation is needed. < 1000 ppm Normal (Display Wohler CDL 210) No further ventilation is needed. Poor (Display Wohler CDL 210) >...
  • Page 11 Operation Power on/off ATTENTION! Calibrate the Wohler COL 210 at fresh air, before using it fort he first time ( see chapter 8 ) . Plug in the power supply and the meter turns on automatically with a short beep. The readings will immediately appear in the display.
  • Page 14 PC Software Wohler CDL 21 0. • Insert the plug of the USB cable into the sock­ et of the rear side of the Wohler CDL 21 0. • Insert the USB plug into the USB interface of your PC.
  • Page 18 Setup Setting the CO In the P 1.3 mode the current set value will be blinking and the flat icon will appear (see Abb. alarm limit 10). • Press LOG/.& to increase or MIN/MAXT to decrease the value. Each press tunes 100 ppm. NOTE! �...

  • Page 22: Reset

    Setup • Reset normal mode press and hold the SET key for three seconds to enter P1 .0 mode. rS� • Press LOG/.& three times to enter P4.0 mode for reverting the meter to default status, see Fig. 17. • Press SET to enter P4 .1 mode with blinking "No"...

  • Page 27: Service

    TestEquipmentDepot.com Declaration of Conformity The product: Name: CO2-Logger Model: CDL 210 has been tested in accordance to essential protection requirements of Council Directive 2014/30/EU and found the test results indeed meet the limitation of the relevant test standards listed below:...

Table of Contents