In-Car Connection - Philips AX2003/18A User Manual

Esp4 jogproof

Hide thumbs

Table Of Contents

Table of Contents

FEATURES

ESP

Conventional portable CD-players subjected to a shock

or vibration during playback often skip parts of the CD. The

ELECTRONIC SKIP PROTECTION (ESP) feature, with which

your set is equipped, however, prevents such loss of

continuity when your player is subjected to light vibrations.

But ESP does not prevent playback interruptions caused by

vigorous exercise. Nor does it protect against damage

resulting from the player being dropped!

• Press ESP during playback to activate the skip

protection.

is shown and the protection is activated.

ESP

• To deactivate the skip protection, press ESP again.

goes off and the protection is deactivated.

ESP

In-car use

(connections supplied or optionally available)

Only use the AY 3545 car

voltage converter (4.5V, DC,

positive pole to the centre pin)

and the AY 3501 car cassette

adapter. Any other product may

damage the set.

1 Put the CD-player on a

horizontal, vibration-free and

stable surface. Make sure it

is in a safe place, where the

player is neither a danger nor obstacle to either driver or passenger.

2 Connect the DC plug of the voltage converter to the 4.5V DC socket of the CD-

player (only for a 12 V car battery, negative grounding) .

3 Insert the voltage converter into the cigarette lighter socket. If necessary, clean the

cigarette lighter socket to obtain a good electrical contact.

4 Turn down the volume and connect the cassette adapter plug to the LINE OUT/p

socket of the CD player.

5 Carefully insert the cassette adapter into the car radio's cassette compartment.

6 Make sure the cord does not hinder your driving.

7 Start the CD-player, set VOL E to position 8 and adjust the sound with the car

radio controls.

• Always remove the voltage converter from the cigarette lighter socket when the

CD-player is not in use.

Note: – Avoid excessive heat from the car heating or from direct sunlight (e.g. in a

parked car in the summer).

– If your car radio has a LINE IN socket, it is better to use this instead of the

cassette adapter. Simply connect a signal lead from the LINE OUT/p socket

of the CD-player to this LINE IN socket.