Wlan Management - 2.4G; Operation Mode; Wlan 2.4G - Delta DVW-W1I2-E1 Series User Manual

Starting from MODBUS address and connecting to monitored data
size.
Format
Set format to Hex, Dec, Bin (hexadecimal, decimal, binary).
When add or edit coil device types, format is not required.
Online
Set or not to set data display on MODBUS monitoring table.

3.4 WLAN management - 2.4G

The WLAN management focuses on configuring 2.4G WIFI operation mode and its corresponding parameters.
Please refer to the manual for accurate configuration before setup.
3.4.1

Operation mode

DVW-W01I2-E1 provides 2 different WIFI operation modes including AP and client mode that allow users to
easily configure wireless network environment. Please first set DVW-W01I2-E1 operation mode, then
configure WLAN.
RF
To enable or disable wireless function.
Operation mode
Set wireless operation mode:

AP mode: used as an intermediate point for wired and wireless
devices connection, data transmission and more.

Client mode: DVW-W02W2-E2 operating in client mode can
perform wireless data transmission via AP.
Region
Show the country or region for the device (display only, can't revise by
user)
Attention
2.4G and 5G WIFI cannot operate in client mode simultaneously.

3.4.2 WLAN 2.4G

The setting page focuses on the basic and adanced configuration of 2.4G network in AP or client mode.
Explanation
Description
Ch ap te r 3 Fu nc tion G uide
Default value
None
Hex
Not checked
Default value
Enabled
AP
U.S
3_
3 - 2 5