General Information; Environmental Information; Acknowledgement; Supplied Accessories - Philips FW788P/P22 User Manual

IMPORTANT!
PLEASE NOTE THAT THE VOLTAGE
SELECTOR LOCATED AT THE REAR OF
THIS SYSTEM IS PRESET AT 220V FROM
THE FACTORY. FOR COUNTRIES THAT
OPERATE AT 110V-127V, PLEASE ADJUST
TO 110V-127V BEFORE YOU SWITCH ON
THE SYSTEM.

Environmental Information

All unnecessary packaging has been omitted. We
have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags,
protective foam sheet).
Your system consists of materials which can be
recycled and reused if disassembled by a
specialised company. Please observe the local
regulations regarding the disposal of packaging
materials, exhausted batteries and old
equipment.

Acknowledgement

Energy Star
R
As an ENERGY STAR
Partner; Philips has
determined that this product
meets the ENERGY STAR
guidelines for energy efficiency.

Supplied accessories

– Remote control
– Batteries (two AA size) for remote control
– AM loop antenna
– FM wire antenna
– AC power cord
pg 001-027/C788/21-Eng
G Before operating the system, check that the
G Place the system on a flat, hard and stable
G Place the system in a location with adequate
G Do not expose the system, batteries or discs to
G If the system is brought directly from a cold to a
G The mechanical parts of the set contain self-
G When the system is switched to Standby
R
7

General Information

Safety Information

operating voltage indicated on the typeplate (or
the voltage indication beside the voltage
selector) of your system is identical with the
voltage of your local power supply. If not, please
consult your dealer.
surface.
ventilation to prevent internal heat build-up in
your system. Allow at least 10 cm (4 inches)
clearance from the rear and the top of the unit
and 5 cm (2 inches) from each side.
excessive moisture, rain, sand or heat sources
caused by heating equipment or direct sunlight.
warm location, or is placed in a very damp room,
moisture may condense on the lens of the disc
unit inside the system. Should this occur, the CD
player would not operate normally. Leave the
power on for about one hour with no disc in the
system until normal playback is possible.
lubricating bearings and must not be oiled or
lubricated.
mode, it is still consuming some power.
To disconnect the system from the
power supply completely, remove the AC
power plug from the wall socket.
12/11/01, 5:29 PM
7
3139 115 21171