4 MODIFYING THE DC POWER
It is possible to modify the DC power to prevent the TKR-
750/858/751/851 is turned ON with the erroneous
operation of the power switch. With this modification, the
DC power is always turned ON regardless of the power
switch operation.
Follow the procedures below to modify the DC power.
It must turn the power OFF before DC power modification.
1. Remove the front side top panel.
Remove 6 screws (N33-3006-45, 3 mm diameter,
black) and pull the TX-RX PANEL up.
2. Solder the PSW part located on the left side of the TX-
RX unit (A/2) to make a soldering bridge.
Solder here to bridge.
3. Reassemble the repeater after modifying the DC
power.
Version: 1.02 USA
TX-RX unit (A/2)
Modification Information (MOD)
12