INDICATIONS FOR USE: FIRE AND MECHANICAL HAZARDS ONLY IN ACCORDANCE WITH UL The Calamus Flow Obturation Delivery System is an obturation 60601-1 (First Edition) and CAN/CSA delivery system and hand piece device that is used for heating C22.2 No 601.1-M90.
The patient should be advised to notify you immediately if any of these symptoms occur. PACKAGE CONTENTS: • Calamus Flow Obturation Delivery Device • Remote Power Cord (110V)* ..PN: 840079 • Cartridge Needle Bending Tool ..PN: 461270 •...
STEP-BY-STEP INSTRUCTIONS SETTING UP THE UNIT: 1. Unpack the console and check that the Voltage 5. Install a cartridge into the hand piece: Unscrew Selector is set to the proper voltage. Use the110 and remove the cartridge nut from the hand setting for 110-120V 60Hz voltages, and the 220 piece.
OPERATION: After the unit has been set up, you are ready for c. To store your new settings, press and hold either operation as follows: Preset button until the Preset LED illuminates 1. Press the Power switch on the front of the console (approximately two seconds).
REPLACING A CARTRIDGE: NOTE: When replacing a Calamus Singles II cartridge during a procedure, the hand piece cartridge nut and expended cartridge are hot to the touch. 1. Select a 20 or 23 gauge cartridge. 2. Retract the delivery plunger by pressing the Return button. 3.
STERILIZATION, DISINFECTION & MAINTENANCE: Control Console – Clean the exterior of the console by wiping with a soft cloth moistened with a mild detergent or disinfecting solution. The system is designed to allow for a disposable sani- tary plastic barrier to be utilized over control console and/or hand piece. Hand Piece –...
DENTSPLY makes no warranty other than that stated above, expressed or implied. Contact DENTSPLY Tulsa Dental Specialties Technical Department at 1-800-662-1202 for repair authorization and shipping instructions. NOTE: In the interest of serving our customers more efficiently, customers receiving service on non-warranted repairs are expected to accept charges that are less than $250.00 without further notification.
Need help?
Do you have a question about the Calamus Flow and is the answer not in the manual?
Questions and answers