Advertisement
Brought To You By Augusta Flint
Step 7)
Attach each of the four (4) Axle Caps (from Bag part K) to the Axles.
Step 8)
Insert the lower part of the Handle (part B) into the Steering Assembly (part J).
Slide the 2-5/8" Bolt into the Assembly and through the Handle so that it
exits the other side of the Assembly. Tighten the Bolt into place with a Small
Washer and Nut Cap.
Step 9)
Turn the Wagon upright. Attach one (1) of the Long Side Panels (part E) to the
wagon with the three (3) 1-3/4" Bolts going through both the Tray and each vertical slat.
The top of the Bolts should be on the inside of the Tray. Tighten each into place with a
washer then a Nut Cap.
Note:
The Short Front Panel (part G) is the one with a downward curved front slat.
Step 10)
Attach the Short Rear Panel (part F) to the wagon with two (2) 1-3/4" Bolts going
through the Tray (A) and each vertical slat. Tighten into place by sliding on the
washer followed by the Nut Cap.
Step 11)
Attach the second Long Side Panel (part E) as in step 9. Attach the Short Front
Panel (part G) with two (2) 1-3/4" Bolts. Tighten into place with the Washer and
Nut Cap as previously described.
Your Wagon has a long handle mounted at the front. Use the handle to pull the wagon to your destination, as
well as transporting loads to and from your destination.
Turning the Handle (part B) will cause the front wheels on the wagon to turn. Turn the Handle in the direction
that you wish the wagon to go. The Handle can be raised for steering from inside the wagon, or lowered so
that the wagon can be pulled from in front.
if there is any question about a condition being safe or unsafe
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE
IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO
REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR
EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES
ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT
OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THERETO.
#32826
Operation
PLEASE READ THE FOLLOWING CAREFULLY
REV 02g
,
.
W
do not operate the
agon
Page 4
Advertisement
