LiteOn Leotek Eseta Installation Manual
LiteOn Leotek Eseta Installation Manual

LiteOn Leotek Eseta Installation Manual

Wall sconce with emergency battery pack

Advertisement

Installa'on Guide
This procedure is designed as an installaKon aid. Skilled trades people that are familiar
with general construcKon and electrical installaKon techniques should perform the
installaKon. Licensed electricians should provide electrical installaKon connecKons.
InstallaKons and connecKons should be done in accordance with all naKonal and local
codes and permits. In no way is this document intended to construe warranty or fitness
of use of the products described, nor is it intended to provide safety instrucKon for those
installing the product.
WARNING
When using electrical equipment, basic safety precau6ons should always be followed including the following:
-  Do not mount near gas or electric heaters
-  Equipment should be mounted in loca6on and at heights where it will not be subjected to tampering by
unauthorized personnel.
-  The use of accessory equipment not recommended by the manufacturer may cause an unsafe condi6on
-  Do not use the equipment for other than its intended use.
Before proceeding with installaKon or service maintenance of this product:
•  Disconnect power to reduce electrical shock risk.
•  Review the en6re Installa6on Guide.
•  Inspect this properly packaged product for any damage that may have occurred during transit.
•  Verify product applica6on complies with manufacturer design recommenda6ons.
•  Verify the availability of necessary tools and incidental material.
•  Verify applicable code requirements. Field assembly and installa6on are subject to acceptance by
local inspec6on authority.
•  Appropriate safety equipment to be determined by end user, per applicable safety standards and
precau6ons.
With Emergency Ba;ery Pack
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
SAVE THESE INSTRUCTIONS
LED Outdoor Luminaires
Eseta
wall sconce
TM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Leotek Eseta and is the answer not in the manual?

Questions and answers

Summary of Contents for LiteOn Leotek Eseta

  • Page 1 LED Outdoor Luminaires Eseta wall sconce With Emergency Ba;ery Pack Installa'on Guide This procedure is designed as an installaKon aid. Skilled trades people that are familiar with general construcKon and electrical installaKon techniques should perform the installaKon. Licensed electricians should provide electrical installaKon connecKons. InstallaKons and connecKons should be done in accordance with all naKonal and local codes and permits. In no way is this document intended to construe warranty or fitness of use of the products described, nor is it intended to provide safety instrucKon for those installing the product.
  • Page 2 MounKng – Surface/Direct Mount Step 1 – Remove two screws on the boTom of Eseta and remove moun6ng bracket on the back of the luminaire. Step 2 – Place moun6ng bracket on the wall (follow the arrow direc6on on the bracket). Secure moun6ng bracket with four screws. Step 3 – Hang Eseta on the mounting bracket. Step 4 – Connect wiring to customer supplied junction box . Connect the black wire to hot wire, connect the white wire to the neutral, connect the red wire with ON/OFF switch wire, and connect the green wire to the ground.

Table of Contents