Advertisement
Control of burner functions
The control circuit board includes a display and three programming keys: "Enter", "Plus" (+)
and "Minus" (-).
The following symbols can be displayed:
The control system is pre-set for the type of burner delivered.
For changing a function, press ENTER, and the value last entered will be displayed.
Example:
The text „RUNTIME 8 SEC" is being displayed: This means that the feed auger is set to run 8
seconds at a time. If you want to change this value, press ENTER once again, so that an aste-
risk (*) appears behind the figure 8. Now press the plus (+) or minus (-) key, until you obtain
the feed time you wish, and confirm the new value by pressing ENTER (now the asterisk dis-
appears). After some 5 seconds, the burner status with all its symbols will be displayed again.
If you want to change a different function, press the plus (+) or minus (-) key until the func-
tion you want to change is displayed, and then change the function as described above.
Photocell mode: Light
Fan(s): Operating
Ignition coil: Operating
Operating thermostat: On
Photocell mode: Dark
Feed auger(s): Operating
Operating thermostat: Off
Thermostat delay
Advertisement
