IHP SG-01 Installation Instructions

INSTALLATION INSTRUCTIONS FOR STANDARD SAFETY GUARD KIT
FOR USE ON IHP GAS FIREPLACE MODELS LISTED IN TABLE 1
KIT CONTENTS
• (1) ea. Safety Guard
REQUIRED TOOLS
• No Tools Required
GENERAL INFORMATION
This optional Safety Guard is designed to reduce the risk of burn
injury associated with incidental contact with the glass front of the IHP
and Superior Gas Fireplaces listed in Table 1 on Page 2, when it is
installed and used in accordance with both these instructions and the
warnings, precautions, and instructions included in the INSTALLATION
INSTRUCTIONS AND CARE AND OPERATION manuals provided with
f i r e - p a r t s . c o m
your appliance.
NOTE: Improper or repeated installation and removal of the
optional Safety Guard could scratch, dent, or otherwise deface
the metal frame surrounding the glass front of the appliance.
NOTICE
• READ ALL STEPS BEFORE STARTING INSTALLATION.
• THESE INSTRUCTIONS MUST BE LEFT WITH THE APPLIANCE.
• ALL WARNINGS, PRECAUTIONS, AND INSTRUCTIONS IN THE
INSTALLATION INSTRUCTIONS AND CARE AND OPERATION MANUALS
PROVIDED WITH THE APPLIANCE ALSO APPLY TO THESE INSTRUCTIONS.
• IF YOU ENCOUNTER ANY PROBLEMS, NEED CLARIFICATION OF THESE
INSTRUCTIONS, OR ARE NOT QUALIFIED TO PROPERLY INSTALL THIS KIT,
CONTACT YOUR LOCAL DISTRIBUTOR OR DEALER.
Fireplace Top Panel
(if applicable)
Fireplace Lower
Access Panel
Figure 1
Front
Glass Panel
Glass Panel
Lower Clamps
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
P/N 506019-67, Rev. D
11/2015
Hot Fireplace Will Cause
INSTALL ONLY WHEN THE FIREPLACE IS OFF AND COLD!
Severe Burns
INSTALLATION INSTRUCTIONS
Never Allow Children to
Step 1. If the fireplace is on, turn it OFF. Allow it to cool completely.
Touch Glass or other Fire-
BEFORE CONTINUING, FIREPLACE MUST BE OFF AND COLD!
place Parts
Step 2. See Figure 1. Remove the fireplace top panel (if applicable).
Step 3. See Figure 1. Open the fireplace lower access panel, and then
release the two glass panel lower clamps.
Step 4. See Figure 2. Hook the Safety Guard top flange over the glass
panel top flange.
Step 5. Firmly insert the Safety Guard bottom flange into the glass
panel bottom flange.
Step 6. See Figure 3. Reclamp the two lower clamps, making sure
to capture the lower flanges of both the Safety Guard and the
glass panel.
Step 7. See Figure 1. Close the fireplace lower access panel. Replace
the top panel, if applicable.
Safety Guard
Top Flange
Glass
Panel
Top
Flange
Glass
Panel
Bottom
Flange
Safety Guard
Bottom Flange
Figure 2
HEARTH PRODUCTS
KITS AND ACCESSORIES
GAS FIREPLACE
STANDARD SAFETY GUARD KIT
WARNING
CAUTION
"Nested"
Bottom
Flanges
Glass Panel
Lower Clamp
(one of two)
Make sure each glass panel
lower clamp captures BOTH
bottom flanges (on Safety
Guard and glass panel).
Figure 3
1