Table of Contents
Advertisement
4 Get started
Caution
•
Use of controls or adjustments or
performance of procedures other than herein
may result in hazardous radiation exposure or
other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Prepare the remote control
Note
•
Risk of explosion! Keep batteries away from
heat, sunshine or fire. Never discard batteries
in fire.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert two AAA batteries with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
3
1
2
44
EN
Note
•
If you are not going to use the remote control
for a long time, remove the batteries.
•
Do not use old and new or different types of
batteries in combination.
•
Batteries contain chemical substances, so they
should be disposed of properly.
Auto install radio stations
When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1
Connect the unit to the power supply.
»
[AUTO INSTALL - PRESS PLAY] (auto
install - press the PLAY button) is
displayed.
2
Press
on the main unit to start
installation.
»
[AUTO] (auto) is displayed.
»
The unit automatically stores radio
stations with sufficient signal strength.
»
When all the available radio stations
are stored, the first preset radio station
is broadcast automatically.
Set clock
1
In the standby mode, press CLOCK to
activate the clock setting mode.
»
The 12 hour or 24 hour format is
displayed.
2
Press ALBUM/PRESET+/- repeatedly to
select 12 hour or 24 hour format.
3
Press CLOCK to confirm.
»
The clock digits are displayed and
begin to blink.
4
PressALBUM/PRESET+/- to set the hour.
5
Press
/
to set the minute.
6
Press CLOCK to confirm.
Advertisement
Table of Contents
