Advertisement
Quick Links
Mechanical Installation for the PS-2040 Power Supply
The PS-2040 Power Supply is mounted into the Network Fire Alarm panel backbox near the bottom. Remove the
transformer cover (held in place by two #8 hex nuts) from the backbox, then mount the power supply using four #8-32
nuts to secure it to the backbox. Replace the transformer cover. Refer to figure below for location of the PS-2040.
Metal plate with ANC-5000 and
TNC-5000 modules aboard fit
into position 1 of the QMB-
5000N Audio Card Cage
QMB-5000N Audio Card Cage
Main Chassis with
provision to mount FNC-2000
Network Controller Module and
2 adder modules/loop controllers
PS-2040 Power Supply and space
to mount 6 adder modules/
loop controllers
Batteries (maximum 40 AH)
Enclosure
Network Power Supply
Installation Instructions
16.5"
16.5"
25"
25"
33.5"
33.5"
LT-6015 Rev. 1
PS-2040
QAA Amplifiers fit
into slot positions 2,
3, 4 and 5.
May 2012 Page 1 of 2
Advertisement
Related Manuals for MGC PS-2040
Summary of Contents for MGC PS-2040
-
Page 1: Installation Instructions
(held in place by two #8 hex nuts) from the backbox, then mount the power supply using four #8-32 nuts to secure it to the backbox. Replace the transformer cover. Refer to figure below for location of the PS-2040. - Page 2 Wiring Connect the white and orange wires to the terminal block above the transformer labelled for the orientation of the wires. The two brown wires from the transformer are connected to the bottom right connector and the top left connector of the bridge rectifier.
Need help?
Do you have a question about the PS-2040 and is the answer not in the manual?
Questions and answers