Advertisement
Quick Links
Installing ExaScale Line Cards
Dell Force10 Catalog Numbers:
LC-EH-10GE-40S, LC-EJ-10GE-40S, LC-EH-GE-50P, LC-EJ-GE-50P, LC-EH-GE-90M, LC-EJ-GE-90M
The E-Series ExaScale requires at least one line card to operate. You can add, replace, or remove line
cards without interrupting the system power or system operations. Any line card can be inserted into any
line card slot.
NOTE: ExaScale line cards have a minimum FTOS version requirement. See
NOTE: All chassis slots must be installed with operational modules or blanks. Always replace cards and blank
panels immediately.
Figure 1-6. Installing a line card
LC-EH-10GE-10P, LC-EJ-10GE-10P, LC-EH-10GE-10S, LC-EJ-10GE-10S,
Table
1-1.
101-00348-05
|
1
Advertisement
Related Manuals for Dell LC-EJ-10GE-10P
Summary of Contents for Dell LC-EJ-10GE-10P
- Page 1 Installing ExaScale Line Cards Dell Force10 Catalog Numbers: LC-EH-10GE-10P, LC-EJ-10GE-10P, LC-EH-10GE-10S, LC-EJ-10GE-10S, LC-EH-10GE-40S, LC-EJ-10GE-40S, LC-EH-GE-50P, LC-EJ-GE-50P, LC-EH-GE-90M, LC-EJ-GE-90M The E-Series ExaScale requires at least one line card to operate. You can add, replace, or remove line cards without interrupting the system power or system operations. Any line card can be inserted into any line card slot.
- Page 2 Installing line cards WARNING: Electrostatic discharge (ESD) damage can occur when components are mishandled. Always wear an ESD-preventive wrist or foot-heel ground strap when handling line cards. Place line cards on an antistatic surface when they are not installed. Step Task Verify that the chassis is running the minimum FTOS version for the line card that you are installing.
- Page 3 10 port 10GE line card with XFP optics (10M LC-EH-10GE-10P XFP optics are required 8.3.1.0 CAM) 10 port 10GE line card with XFP optics (40M LC-EJ-10GE-10P XFP optics are required 8.3.1.0 CAM) 10 port 10GE line card (10M CAM) LC-EH-10GE-10S SFP+ optics are required 8.1.1.1...
- Page 4 LAG is NOT supported on the 4-port 40G line card. • The 4-port 40G line card can be configured for linerate or oversubscribed mode (linecard id [linerate | • oversubscribes] active-ports port-set number CLI in CONFIGURATION mode). The line card must be rebooted when mode or port changes are made. •...