Hookups - Philips DVD580MT99 Owner's Manual

Putting Batteries in the Remote Control
1
Remove the battery compartment lid on the back of the
remote control by pressing in the tab, then lifting off the lid.
2
Place two AA batteries inside the battery compartment
with their + and – ends aligned as indicated. Do not mix old
and new batteries or different types of batteries (standard, alkaline,
etc.).
3
Replace the battery compartment lid as shown at right.
Using the Remote Control
Always point the remote control directly at the remote sensor (IR or
infrared) on the front of the Player, not the TV. Details are on page 18.
Make sure there are no barriers between the remote control and the
Player.
Connecting the Base
A base is provided with the Player to add stability and to allow you to posi-
tion the Player horizontally or vertically, whichever fits your setup situation
best. To connect the base, follow these steps.
1
Use a coin to loosen the screw on the base.
2
Decide whether you want to attach the Player to the base
vertically or horizontally. Turn the Player vertically or hori-
zontally, then find the screw hole in the Player that you
need to use.
If you want to attach the Player to the base horizontally, use the
screw hole that is just below the COAXIAL and OPTICAL jacks.
If you want to attach the Player to the base vertically, use the screw
hole that is to the right of the MULTI-5.1 jack.
3
Place the Player on the base so the screw aligns with the
hole on the Player. Insert and tighten the screw to secure
the Player to the base. Use a coin to tighten the screw.
Hookups (cont'd) 15
Remote Sensor (IR)
Horizontal Attachment
Pr Pr
Pb Pb
Y
S-V ID S-V ID
EO EO
VI DE VI DE
O O
12 V 12 V
CO AX CO AX
IA L IA L FL FL
OP TI OP TI
CA L CA L
SL SL
CE N CE N
TE R TE R
MU LT MU LT
I-5 .1 I-5 .1
FR FR
SR SR
SU BW SU BW
MU LT . .
ICH AN
NE L AU
DIO OU
T
Vertical Attachment