abi Elite Ground Drive Setup Manual page 8

Usage:
Engaging and Disengaging the Drive wheels -
Adjusting the flow -
ABI(
Absolute Innovations, Inc.
ABI Elite Ground Drive Spreader Setup Guide
The ground drive system adds two additional tires to
the spreader. The operator will use the ratcheting turn
knuckle to engage and disengage the tires on the ABI
Elite Ground Drive Spreader. When adjusting the drive
wheels you will need to hook the spreader to your tow
vehicle. Next, to engage the drive wheels you will
shorten the ratcheting turn knuckle. To disengage the
drive wheels you will lengthen the ratcheting turn
knuckle. The drive wheels must be up during transport
or the ABI Elite Ground Drive Spreader will engage and
distribute material while transporting.
Ground Drive Spreader delivers you will need to adjust the
tension on the back springs. To do this you will use a ½"
wrench and tighten or loosen the two nuts on the end of
each spring rod. Keep track of how many turns you make
on each adjustment point. You want to make sure to adjust
the springs on both sides the same, to ensure proper
tension on both sides of the release panel. Doing this will
apply or decrease pressure to the release panel on the
bottom of the spreader. The tension on the release panel
has been pre set at the factory, adjust only if needed.
) - 855-211-0598
To adjust the flow of material that the ABI Elite
- www.abiattachments.com Page 8 of 11