bouncepad Sumo 270 Degrees Mounting Arm Assembly Instructions

Sumo 270˚ Mounting Arm
Assembly Instructions
Tools Required:
Pencil
Drill
Ø6.0mm Drillbit
Ø2.5mm Drillbit
Ø16.0mm Holesaw
10mm Spanner
*or adjustable spanner
Sheet Code: BP-IM-055_REV0
Release Date: 01/10/2019
Copyright 2016 Spotspot Ltd. (T/A
Bouncepad) all rights reserved.
Confidential, no part of this publication
may be reproduced or transmitted in any
form without the written permission of the
copyright holder.
With the correct drill bits,
A3
drill each hole.
With the correct drill bits,
B3
drill each hole.
Remove the adhesive backing &
A7
protective netting, then locate the
Stalk Cover to the mount surface.
5x M6
Locking Nut
Fixings Kit
5x M6 Split
Washer
Sumo Mounting
Arm
5x M6x40mm
Socketset
screw
1x Mount Washer
* Due to the modular nature
of our product range you may
receive additional fixings in
the fixings kit
In the
Fixings
Box
List
A4
See below for step A5
and onwards.
Tighten screw(s) using hand tools, using electric
M6x40mm
Socketset
screw
See below for step B5
and onwards.
B4 A5
Installation
A8
complete.
Follow steps A if "Fixing
A1
from below".
*Bouncepad does not supply the fixings
used in a "Fixing from Above" installation.
Follow steps B if "Fixing
B1
from Above".
tools may damage your Bouncepad.
Attach the socket set
screws into the mounting
arm.
Tighten screw(s) using hand tools, using electric
tools may damage your Bouncepad.
Secure the Sumo Stalk to the mounting surface, with your
B5
chosen countersunk fixings. Ensure all screws are below flush
in the countersunk holes.
Using the template
A2.0
(A2.1 overleaf) mark
the drill hole locations.
Using the template
B2.0
(B2.1 overleaf) mark
the drill hole locations.
Tighten screw(s) using hand tools, using electric
tools may damage your Bouncepad.
Mount Washer
M6 Split Washer
M6 Locking Nut
Locate & secure the Sumo Stalk in its chosen
A6
orientation. Ensure that the correct fixings
are used.
For additional security, we recommend
using Pin-Torx countersunk screws.