Important Safety Information - NorthStar 157495 Owner's Manual

1.) Read all the instructions before using the product.
2.) Make sure that your existing hose, gun, and all accessories are rated for high temperatures and the
appropriate pressure.
3.) To reduce the risk of injury, close supervision is necessary when the product is used near children. Do not
allow irresponsible use by children. Always stop the product and bleed pressures before leaving
unattended, disconnecting hoses, or servicing.
4.) Know how to stop the product and bleed pressures quickly. Be thoroughly familiar with the controls.
5.) Stay alert - watch what you are doing.
6.) Do not operate the product when fatigued or under the influence of alcohol or drugs. Never smoke while
operating or fueling this machine.
7.) Keep operating area clear of all persons.
8.) Do not overreach or stand on unstable support. Keep good footing and balance at all times. Wear footwear
capable of maintaining a good grip on wet surfaces. Do not place the machine on soft or unstable ground.
9.) Follow the maintenance instructions specified in all manuals.
10.) Wear safety glasses, gloves, face protection and appropriate clothing when operating the machine.
11.) Do not operate this machine with broken or missing parts. Never alter the manufacturer's original design or
deactivate any safety device on the machine.
12.) Risk of exposure to dangerous chemicals. Wear protective gloves when handling and cleaning with
chemicals. Follow the chemical manufacturer's directions. Understand all safety hazards and first aid for all
chemicals being used. Do not pump highly abrasive fluids or use with incompatible chemicals or solvents.
13.) Know the pressure and temperature limits of your machine. Be sure all high pressure accessories meet or
exceed your machine's limits. Do not set the rupture disc above the machine's limit.
14.) Do not move this machine by pulling on the hose. Do not attempt to use this machine as a prop.
15.) Do not clean this machine with its own spray. Cleaning should be done with a damp sponge with the
machine OFF.
16.) NEVER attempt to immediately run or re-light the burner if it doesn't ignite the first time. Unburned oil or
gas may have accumulated causing potential explosion or fire hazard.
17.) Always make sure all switches and controls are in the OFF position prior to plugging in the electrical cord.
Do not stand in water while plugging and unplugging electrical cord.
18.) This product is provided with a ground fault circuit interrupter built into the power cord plug. If replacement
of the plug or cord is needed, use only identical replacement parts. Failure to do so will void all warranties.

Important Safety Information

SAVE THESE INSTRUCTIONS
8