Assembly - NorthStar 157495 Owner's Manual

1. Attach handles, see above.
2. Attach wheels, see above.
3. Remove water heater from the pallet. It is recommended that a hoist is used, or that two people lift the unit off of
the pallet. If a hoist is used, use the attachment points shown in the Moving and Handling section on page 16. Do
not try to lift the unit by the hook on the heating coil inside the heat exchanger. The heating coil is not secured to
the frame.

Assembly

5/8 Hex Nut
5/8 Jam Nut
5/8 X 3.5" Hex Bolt
14
To attach handles, use:
5/16 X .75" Flange Bolts (4x)
5/16 Flange Nuts (4x)
To attach wheels:
1.) Slide 5/8 X 3.5" bolt through hub of
wheel.
2.) Spin 5/8 Jam Nut onto bolt. Do not
tighten against wheel.
3.) Slide bolt through hole in frame,
secure with 5/8 Hex Nut.