Ledco R8 Manual

Ultrathin Touch Wheel RF Remote Controller
Model No.: R8/R8-1
1 and 4 zone RGB or RGBW/Touch color wheel/Wireless remote 30m distance/CR2032 batter y
R8
4 Zone RGB/RGBW
Features
● Apply to RGB or RGBW LED controller.
● Ultra sensitive color adjustment touch wheel.
● Each remote can match one or more receiver.
● C 2032 atter y powered. R b
● Operate with LED indicator light.
Technical Parameters
Input and Output
Output signal RF 2.4GHz
( )
Working voltage 3VDC CR2032 ( )
Working current ＜5mA
Standby current
＜10μA
Standby time 1 year
Remote distance 30m(Barrier-free space)
Warranty
5 years
Warranty
User Manual Ver 1.0.7
R8-1
1 Zone RGB/RGBW
LVD RED
Safety and EMC
EMC standard (EMC) EN301 489,EN 62479
Safety standard(LVD)
EN60950
Radio Equipment(RED)
EN300 328
CE,EMC,LVD,RED
Certification
Environment
Ta: -30 O C ~ +55 O
Operation temperature
Case temperature Max.
( ) O
T c: +85 C
IP rating
IP20
Mechanical Structures and Installations
58.5mm
107mm
58.5mm
9mm
To fix the remote, two options are offered for selection:
Option 1: fix the remote' back holder on the wall with two screws.
Option 2: adhere the remote' back holder to the wall with paster.
Operation
● When light is on, touch the color wheel , the indicator will display red.
● To extend battery life, no touch or press key operation after a few seconds,
the touch wheel will enter sleep state, you need press any key to make touch wheel quit sleep state.
Match Remote Control (two match ways)
End user can choose the suitable match/delete ways. Two options are offered for selection:
Use the controller's Match key
Match:
Short press match key, immediately press on/off
key (single zone remote) or zone key (multiple zone
remote) on the remote.
The LED indicator fast flash a few times
means match is successful.
C
Delete:
Press and hold match key for 5s to delete all match,
The LED indicator fast flash a few times
means all matched remotes were deleted.
R8,R8-1 Ultrathin Touch Wheel RF Remote Controller
63.00 mm
C 2032 Battery R
Note: Before the first use,
please remove the protective
film on the battery.
Use Power Restart
Match:
Switch off the power, then switch on power again,
immediately short press on/off key (single zone remote)
or zone key (multiple zone remote) 3 times on the remote.
The light blinks 3 times means match is successful.
. Delete:
Switch off the power, then switch on power again,
immediately short press on/off key (single zone remote)
or zone key (multiple zone remote) 5 times on the remote.
The light blinks 5 times means all matched remotes were
deleted.
Back holder
Page 1