Advertisement
•
Center sink on opening and adhere sink to underneath surface of countertop with silicone
adhesive or other suitable adhesive applied to sink flange. Support sink until adhesive
cures.
Vessel Installation:
Additional items needed for Vessel installation:
Drill Motor with a 2 ¾" and 1 5/8" Hole Saw.
24" Level.
•
Determine installation location on countertop for sink and mark centerline for drain hole.
•
Use a 2 ¾" hole saw and drill a hole using the centerline mark to a depth of 3/8".
•
Next drill a 1 5/8" diameter hole in the middle of the 2 ¾" hole that goes all the way
through the countertop. See Fig. A.
•
Remove material from the 2 ¾" cut to a depth of 3/8". Test fit sink into recess.
•
Run a ¼" bead of silicone in 2 ¾" recess. Place sink into recess and level from side to side
and front to back. Install sink tailpiece through sink and countertop.
•
Silicone should be used under drain flange. See Figure B. After tightening drain, allow silicone
to dry and emove excess sealer. Connect drain trap and associated plumbing. Allow 12 hours for
r
silicone to dry before use.
2 3/4"
1 5/8"
Overhead View
Fig. A
2 3/4"
1 5/8"
Side View
3/8"
Advertisement
