Exclusively Designed
Thank You for choosing our D'Vontz Copper Sink
We appreciate your choice of our product. All the information in this guide is based
upon the latest product information available at the time of publication. We reserve the
right to make changes in product specifications at any time without notice. Please take a
few moments to review this guide, if you have any questions please contact us at 877-322-3600.
Items needed for Installation:
A quality 100% clear silicon sealer.
Plumbing tailpiece designed for sinks without overflows.
Soft cotton rag.
Pencil
Tape Measure
Installation Guide:
Drop In Installation:
Since your D'Vontz copper sink is manufactured by hand, we are unable to provide a
template due to variations that occur in width and length. Please proceed as follows:
NOTE: During the installation of this product, the only sealant or adhesive that is Manufacturer Approved is a
100% Silicone based product. Failure to use Kitchen and Bath 100% Silicone based products will VOID ALL
manufacturer warranties and manufacturer finish warranties. Specifically, the use of Plumbers Putty is
EXPRESSLY PROHIBITED and will VOID ALL manufacturer warranties and manufacturer finish warranties.
Measure width across top of sink from outside edge to outside edge. Approximate width
will be 17". Determine countertop hole size by subtracting 1" from this dimension. Layout
this dimension on countertop and cut hole.
Once countertop hole is cut, set sink inside hole and center. Trace outside rim of sink
lightly with a pencil. Remove sink and apply a 3/8" bead of silicon sealant around hole
centered on the pencil line.
Before setting sink in countertop, prepare and attach drain to sink. We
recommend clear silicone sealant under tailpiece flange. See Figure B. After tightening
drain, remove excess putty or sealer. Allow silicone to dry before removal.
Carefully set sink into countertop hole and sealant. Once positioned, carefully remove
excess sealant from the outside rim of sink with a soft cotton rag while holding downward
pressure on sink.
Sink must set a minimum of 12 hours for sealer to set before putting any movement or
pressure on sink.
Under Mount Installation for Flat Edged Sink:
Measure inside diameter of sink. Subtract one inch from this dimension to obtain
dimension of countertop opening.
• INTERNATIONALLY RECOGNIZED
INSTALLATION GUIDE
Copper Sink