Lubrication Chart - Consew 30 Operating Instructions, Parts List, Maintenance Procedures
Hide thumbs
Also See for 30:
Advertisement
Arm Shaft
LUBRICATION CHART
MOD.
CONSEW SEWING MACHINE
Also
Rebuilt SINGER
Class 31
Machine
15
Arm Shaft
Connecting Rod!
=----""::::::::::-:?,1Fr~?>~l
_____
---1r---,
.ft-------Thread Take-up Lever
Bobbin Winder Frame
Oil Well (See Note)
Bobbin Winder Frame--
Hinge Pin (See Note)
Oscillating Drive Rock Shaft
Lifting Lever
Connecting Rod Joint
Hinge Pin
Needle Bar
Presser Regulating Thumb Screw
Thread Take-up Lever Link
Presser Foot Spring
Presser Bar
Needle Bar Connecting Stud
Lifting Lever Hinge Serew
Oscillating Shaft
Feed Lifting Rock Shaft
Connecting Rod
Oscillating Shaft Crank
Connecting Rod
Oscillating Shaft Crank
Slide Block
Feed Forked
Connecting Rod
. Bell Crank Pin
Bell Crank Spring
-- NOTES-
The machine should be oiled twice a day by' applying from one to three
drops of lubricating oil
0"
to each of the oil can points indicated above
by an arrow. Do not flood these moving parts with ojl nor ignore the
four hour lubricating interval.
BOBBIN
WINDER-Every day lubricate the bobbin winder frame oil
well and bobbin winder frame hinge pin with one or two drops of
lubri~
eating oil
iJilI).
FACE ASSEMBLY-Every week the face plate should be removed and
the uncovered bearings and joints lubricated with two or three drops of
lubricating oil
fl'IIiIII).
SHUTTLE RACE-Twice every day apply lubricating oil _
to the
shuttle bearing in the shuttle race, at the same time rubbing two or
three drops of oil over the surface of the shuttle race itself.
Every
week remove the shuttle body from the shuttle race, clean and lubri.
cate it.
Pi
R:.
]
Advertisement
