Download Print this page

Auto Meter EP-800 E-POWER Operating Instructions

2650-1992-77

This unit can be used to jump start a dead battery in a vehicle, or to charge an electronic accessory that is charged with a USB cord. The

E-Power comes equipped with a pair of battery jump start leads, plus 2 ports for USB-A, (labeled as Output 1 & 2) and one port for USB-C

(labeled as In(Out)).

Before using the E-Power, make sure that it is fully charged. This unit is charged through the USB-C port. A 12" long charging cord is included.

One end with USB-C to plug into the E-Power ( to the port labeled In(Out) ), and the other end is USB-A that you can plug into a cell phone

charger port, a USB port in a vehicle, or a computer USB port.

Charfging Cord

When jumpstarting a vehicle, the jumper cables plug into the E-Power as shown below. The port for plugging in the jump cables is located

under a protective cover, which has an automobile icon.

Cables Module

EP-800 E-POWER

OPERATING INSTRUCTIONS

Note the power

switch on the side

of the unit.

Table of Contents

Need help?

Do you have a question about the EP-800 E-POWER and is the answer not in the manual?

Page 1 EP-800 E-POWER OPERATING INSTRUCTIONS 2650-1992-77 This unit can be used to jump start a dead battery in a vehicle, or to charge an electronic accessory that is charged with a USB cord. The E-Power comes equipped with a pair of battery jump start leads, plus 2 ports for USB-A, (labeled as Output 1 & 2) and one port for USB-C (labeled as In(Out)).
Page 2 SERVICE For service send your product to Auto Meter in a well packed shipping carton. Please include a note explaining what the problem is along with your phone number. If you are sending product back for warranty adjustment, you must include a copy (or original) of your sales receipt from the place of purchase.