Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Doro mBox
Summary of Contents for Doro mBox
- Page 1 Doro Care mBox with bed/chair sensor User Guide English...
-
Page 2: Table Of Contents
Dispose of used batteries shall be done in an environmental friendly way. See environmental information. PACKING CONTENTS • mBox 869MHz including mounted batteries. • Chair or bed sensor (mat or stick version) • Mounting plate... -
Page 3: Read First: Safety Information
Doro Care mBox 869MHz OVERVIEW Indicator lamp Sliding cover Reset button Plastic cable cover On/off switch Micro-USB Indicator lamp Green short light Confirmation of alarm is indicated with a short green light. Constantly green light The unit is powered by external power. -
Page 4: Basic Functions
10seconds. Loss of pressure for less than 10 seconds will not send an alarm. C – Bed/chair alarm 15 minutes When mBox are set to position C, the unit is working the same as in position B, but allowing 15 minutes absence (loss of pressure) before an alarm is sent. -
Page 5: Installation
Doro Care mBox 869MHz INSTALLATION Bed/chair alarm placement There are two different types of sensors for both bed and chair: Mat version: Suitable for normal type beds/chairs used in the home. • Place the bed sensor between the bed mattress and mattress protector and beneath the bed sheet in height of the shoulder blade. - Page 6 Doro Care mBox 869MHz Stick version: Suitable for bed/chair with a solid hard surface or a frame structure like a hospital bed or air mattress. The stick version sensor should never be placed on top of the mattress or chair cushion. It’s designed to go under the mattress or cushion. The sensor has two sensing levels, button side downwards for high sensitivity or with flat rib side downwards for less sensitivity.
-
Page 7: Mbox Preparation
869MHz mBox preparation Open the sliding cover of the mBox and install 2 x AA batteries with good quality or if batteries are pre-installed, remove the protective strip from the batteries. Fix the mBox with the provided screws or with the accessories: •... -
Page 8: Connection
Doro Care mBox 869MHz Connection The mBox needs to be connected with the carephone to be able to send the alarms to the Alarm Receiving Center. The mBox also Open the sliding cover completely and remove the plastic cable cover in the bottom of the unit. -
Page 9: Maintenance
Doro Care mBox 869MHz MAINTENANCE Cleaning The devices should be cleaned using a slightly damp cloth. Solvents should not be used when cleaning. Replace the batteries Battery should be replaced after battery alarm or within 2 years, please refer to the service manual or contact your supplier. - Page 10 • Wired installation must be performed only by authorized persons in accordance with the instructions in the service manual. DECLARATION OF CONFORMITY Hereby Doro declares that this radio equipment is in compliance with the essential requirements and other provisions of Directives 2014/53/EU and 2011/65/EU. The comprehensive declaration of conformity is available at the address: Doro AB, Box 10030, SE-952 27 Kalix, Sweden.
- Page 11 Doro Care mBox 869MHz...
- Page 12 © 2019 Copyright Doro AB English Manual_Doro_Care_mBox_869-bed-chair_sensor_en_A5_v10...
Need help?
Do you have a question about the mBox and is the answer not in the manual?
Questions and answers