Table of Contents
Advertisement
Operating Parameter List —
Parameter
Meaning
Counting
mode
Decimal places 1 / 2 / 3 / 4 / 5 / 6 (up to 8 with inch display)
Decimal point
Linear error compensation
Compensation – 99 999,9 < P41 < + 99 999,9 [µm/m]
Reference
marks
Reference mark
evaluation
Encoder
Encoder
monitoring
Baud rate
Additional line feeds
Value for
Preset
datum
Reset/Preset
Display after
Message
switch-on
Inhibit PRINT
Mode
function
1)
Determine entry value for P41
Example: Displayed measuring length L a = 620.000 mm
Actual length (determined with, for example, the VM 101
comparator system from HEIDENHAIN) L t = 619.876 mm
Length difference ∆L = L t – L a = –124 µm
Compensation factor k:
k = ∆L / L a = –124 µm / 0.62 m = –200 [µm/m]
continued
Function / Effect
0 - 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 0
0 - 2 - 4 - 6 - 8 - 0
0 - 5 - 0
1)
One reference mark
Distance-coded with 500 • SP
(SP = signal period)
Distance-coded with 1000 • SP
(e.g. for LS 303 C / LS 603 C)
Distance-coded with 2000 • SP
Distance-coded with 5000 • SP
Evaluation
No evaluation
No monitoring ( Alarm Off )
Contamination
Frequency
Contamination and frequency
110, 150, 300, 600, 1200, 2400, 4800, 9600
0 to 99 ( Linefeed )
Enter numerical value for datum setting with
the ENT key
No zero reset/preset with CL/ENT
Zero reset with CL ( Set Zero ),
no preset with ENT
Zero reset with CL and
preset with ENT to value in P79
message displayed
message not displayed
PRINT inhibited
PRINT not inhibited
Setting
Advertisement
Table of Contents
