Advertisement
5. Dimensions and drilling of cover vice
The vice jaw and spacer should be made of fine-grained hard wood eventually plywood.
Fix the cover vice with spacer so that the top edge jaw is flush with the top of the workbench
board. That's why should be made clamping jaw with of the conduit cassette with finish
allowance. Dimensions spacer underneath the cover vice see page No.2, Fig.2a.
Fix the cover vice with spacer axially symmetrical so that spacer is not interfered a guiding
grooves of the conduit cassette.
Cover vice use after screw as template drilling hole
∅
HV519S) at
40 for nut. If the workbench has a collar, nut is secure sole piece and screw M8
from the inside the workbench. See Fig.2c. If the workbench has no collar it is possible nut use
not securing (that is hardly mounting clamping jaw).
Fig. 3
∅
HV519(S) -
14
HV 581 - xxxx
HV519(S) -
HV581
Page 4 (of 7)
∅
14 for securing pins (only HV519 and
∅S
mm ["]
L
mm ["]
6-8
L=min50
[(0,24"-0,32"]
[(L=min2"]
Fix the cover vice with spacer axially
symmetrical
∅
40
∅
-
40
∅
ks
∅4-6
6
]
[0,16"-0,24"
Advertisement
