Goldair Platinum Series Manual page 5

1.Front Grill
2.Blade Cap
3.Fan Blade
4.Guard Knob
5.Rear Grill
6.Control Switch
7.Oscillation Pin
8.Motor Housing
9.Fixing Screw A
10.Inner Pole
11.Fixing Screw B
12.Main Pole
13.Fan Base
14.Pole Nut
15.Safety Screw
Carefully unpack to fan and remove all of
the packaging materials.
Pick out the fan base and pole parts (10 –
12) and remove the pole nut from the main
pole. Insert the main pole into the hole on
the top of the fan base and whilst holding it
in place, turn over to access underneath.
Lock the main pole into place by securing
with the pole nut. Tighten securely then
turn the assembly the right way up and sit
on a flat surface.
Release fixing screw B and pull the inner
pole out of the main pole. Adjust to a
favourable height, then tighten it with fixing
screw B.
Remove fixing screw A from the inner pole
and place the motor housing assembly on
top. Tighten with fixing screw A to secure
into place.
Remove the blade cap and guard knob
from the shaft of the motor housing.
Components
Assembly
Secure the rear grill onto the motor shaft,
using the 3 pins to align it, keeping the
carry handle at the top. Screw on the
guard knob to keep the rear grill in place
securely.
Push the fan blade onto the motor shaft
until fully seated and secure with the
blade cap.
Open the guard clips around the front grill
and put into position, to match up with the
rear grill. The hook on the front grill
should hook over the top of the rear grill.
Close all of the guard clips and tighten the
safety screw at the bottom of the guard.