Table of Contents
Advertisement
Brought To You By Augusta Flint
5.
NOTE: When connecting the Power Cord (not included) to the wires in the
Switch Board Box (part #27), make sure to run the end of the Power Cord up
through the opening located at the bottom of the Switch Board Box. Then, use
wire connectors (not included) to connect the wires. (See Figure G.)
6.
Once the wires are connected, make sure to re-attach the Switch Board Box
Cover (part #30). (See Figure G.)
SWITCH BOARD BOX
(#27)
RUN POWER CORD UP
THROUGH BOTTOM
SWITCH BOARD BOX
1.
If using a 120 volt AC system to power the Compressor Motor, plug the Power
Cord into the nearest 120 volt, grounded, electrical outlet. The Compressor
Motor will immediately turn on.
2.
If using a 230 volt AC system to power the Compressor Motor, plug the Power
Cord into the nearest 230 volt, grounded, electrical outlet. The Compressor
Motor will immediately turn on.
3.
The Compressor Motor is also equipped with a resettable Overload Switch
(part #28). If while using the Compressor Motor the Overload Switch trips to its
OFF position, electrical power to the Motor will automatically be shut off. This
usually indicates an excessive voltage drain on the unit or overheating. To reset
the Overload Switch to its ON position and restore electrical power to the Motor,
simply depress the Overload Switch's Button Cover (part #12) once.
(See Figure E.)
4.
When finished using the Compressor Motor, grasp the Power Cord's Plug
when disconnecting from the electrical outlet. Do not pull on the Power Cord .
SKU 03068
POWER CORD
(NOT INCLUDED)
COVER
(#30)
OPERATING INSTRUCTIONS
PAGE 13
NOTE:
MAKE SURE TO CONNECT
POWER CORD'S
GREEN WIRE
TO
GROUND SCREW
ON MOTOR.
FIGURE G
Advertisement
Table of Contents
