Table of Contents
Advertisement
Brought To You By Augusta Flint
NOTE: For additional information regarding the parts mentioned in the following pages,
refer to the Assembly Diagram on page 15.
The Compressor Motor features four slotted holes in its Base (part #8) by which
1.
to mount the Motor on a mounting surface. (See Assy. Diagram.)
2.
Make sure there are four holes in the mounting surface that will align with the
four slotted holes in the Base of the Compressor Motor.
3.
When connecting a fan belt from the air compressor to the Shaft (part #5) of the
Compressor Motor, make sure the pulleys (not included) of the air compressor
and Compressor Motor are properly aligned or Motor life will be significantly
shortened. To align the pulleys, simply slide the Compressor Motor foward or
backward on the mounting surface. Once the pulleys are aligned, use four bolts,
four flat washers, four lock washers, and four nuts (not included) to secure the
Compressor Motor to the mounting surface.
1.
The Compressor Motor is designed to operate on either 120 VAC or 230 VAC
single phase circuits. Additionally, the Motor may be wired to either run in a
clockwise or counterclockwise rotation. Proper wiring ensures maximum effi-
ciency and safe operation.
2.
With a phillips screwdriver, remove the Screw (part #31) and remove the Switch
Board Cover (part #30) to expose the six number/color coded wires in the
Compressor Motor. (See Figure E.)
OVERLOAD SWITCH
BUTTON COVER (#12)
SCREW (#31)
SWITCH BOARD COVER (#30)
SKU 03068
MOUNTING INSTRUCTIONS
WIRING INSTRUCTIONS
SHAFT
(#5)
PAGE 11
FIGURE E
Advertisement
Table of Contents
