Advertisement
2. Install the facade onto the fireplace face per instructions in Figure 2.
Align the tabs on the
bracket assemblies all
the way into the slots
on fireplace, then push
facade down to ensure
engagement.
Slots on Fireplace
(2 places each side)
Note: There are two
mounting positions on the
facade hanging brackets
to better accommodate a
range of facing thick-
nesses. Adjust to the
notch on the hanging
bracket that works best
for your installation.
Figure 2 - Install Facade
3. Install the left and right side gates as shown in Figures 3 and 4. The
hinges on the gates hang on the hinge pins on the facade.
Door Hinge
Facade Hinge Pin
Figure 3 - Align Door Hinges Over Facade Hinge Pins
Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and the discontinuance of colors, styles and products. Consult
your local distributor for fireplace / insert code information.
Printed in U.S.A. © 2008 Lennox Hearth Products
p/N 750,253M REV. NC 06/2008
2
Facade
Tabs on Bracket
Assemblies (2
places each side)
4. See Figure 5 for instructions on accessing the control compartment.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Ensure that hinge is
fully seated as shown
Door Hinge
Facade Hinge Pin
Figure 4 - Lower Door Over Pins Until Fully Seated
The gated doors must be open to access the control compartment
door. To open; pull doors open until magnet latches release.
Magnet
Control Compartment
Control Compartment Door
To open, pull the hinged door forward and down as shown. To close, hinge
the door closed until magnets secure it in place.
Figure 5 - Opening the Control Compartment Door
Completed
Installation
Figure 6
Lennox hearth products
0 west Taft Avenue • Orange, CA 92865
Magnet
Advertisement
