Measuring Volumes; Locating Concealed Objects - Kompernass KH 3236 Operating Instructions Manual

Measuring volumes

1. Slide the function switch
The display 2
2. Press the button MODE
3. Press the button READ
measured length appears and „W" (Width) starts to flash.
4. Press the button READ
measured width appears and „H" (Height) starts to flash.
5. Press the button READ
in the upper line. In the lower line appears the result of the volume calculation.
Adding volumes together
1. Measure a volume as described in the section „Measuring volumes".
2. Press the button M
The volume measured is now saved.
3. Press the button MODE
measurement.
4. Measure the next volume.
5. Press the button +/=
6. Press the button RM
lower line.
7. Press the button +/=
the result is shown in the lower line.
8. Repeat the steps 2 to 7 to add in further measurement values.
9. When you wish to leave the addition mode, press the button MODE
All values are erased.

Locating concealed objects

Notice:
• Before using the appliance for this task, first test it by locating a pipeline
or electrical power cable at a known position.
• In cases of doubt, always ask a qualified building contractor.
Attention!
Should the appliance find a live wire carrying alternating current,
appears in the display. Under no circumstances should you drill at this
location! Danger of electric shock!
q to „Distance".
switches itself on.
4 twice. In the display
6 , to measure the length. In the upper line the
6 to measure the width. In the upper line the
6 to measure the height. The measured height appears
7
. „M+" appears in the display
4 . The appliance is now ready for the second
r . A „+" appears in the display
w . The result of the first measurement is shown in the
r . Both measurements are added together and
2 flashes „L" (Length).
- 8 -
2
.
2 .
4 .