iBeam TE-PSCD Product Manual

The iBEAM TE-PSCD parking sensor kit consists of 4 ultrasonic sensors, a rearview mirror or
external monitor video input/output with audible warning detection all intergraded into the
control box. The system detects the distance between the vehicle and any obstructions with the
use of the ultrasonic sensors mounted in the bumper, external camera (purchased separately) to
external monitor (purchased separately) video display and an audible warning device.
I. Specifications
Rated Voltage: 12V (9-16V)
Rated Current: 20mA~200mA
Detecting Distance: Rear (0' – 5') Front (0'- 2.5')
Ultrasonic Frequency: 40Khz
Working Temperature: -22°~176°F
II. Connection
Insert Wiring Diagram
1) Sensors should be 1.5 to 2.5 feet from the ground, and 4 ¾ to 7 ¾ inches apart from each
other (depending on vehicle application).
2) Install parking sensors by drilling holes out of the back bumper with the supplied 19mm
hole saw bit (make sure when using the angle adapters the thicker side is facing down,
level with the ground and the UP arrow on the back of the sensor is facing up), and install
parking sensors.
3) The rear sensors A/B/C/D should be installed from left to right (looking at the bumper).
This is also how they should be plugged into the control box. (Example A: left, B: mid-
left, C: mid-right, D: right)
4) Connect the RED wire to the +12 volt accessory wire.
5) Connect the BLACK wire to a ground (a metal, non-painted surface).
6) Plug that wiring harness into the parking sensor control box (labeled power)
7) Run the audible warning device cable through the vehicle and mount somewhere in
vehicle's cabin where the device can be clearly heard with no obstructions (avoid placing
cable where it can get pinched or damaged) and plug cable into the control box (labeled
buzzer).
TE-PSCD
Product Manual