Note Panel wall installation should conform to local building codes. The installation instructions provided are for the Amico standard products. Slight modifications to the installations may be required. The product shipped to the job site may not be exactly as shown on the installation drawings.
1. Mark the horizontal line for the mounting bracket: 7” below ceiling line. This line will be used to Figure 2) Mounting bracket is one piece for locate drilling for mounting of hanging bracket. (see all sections, please see Figure 3. 7” below finish ceiling Figure 2 Figure 3 www.amico.com...
Page 4
2. Align bracket horizontally according with headwall mounting location. Refer to drawings. Mount bracket to the wall using hardware compliant to local building codes (supplied by others). En- sure hanging bracket is secured to the wall studs or blocking behind the drywall (see Figure Figure 4 Amico Architectural...
Page 5
Installation 3. Prepare units to be hang over the mounting bracket a. Headwall will be delivered in multiple sections, please see approved drawings for exact number ( see Figure 5 for references only) Figure 5 www.amico.com...
Page 6
Hang all units in place and make sure the bottom line up for all sections. Figure 6 Figure 7 d. Secure units through lower rear bracket to wall, where applicable. (Figure 7) e. Secure each section to each other using the hardware provided by Amico. See Figure 8 for details. Figure 8 Amico Architectural...
Need help?
Do you have a question about the Freedom Series and is the answer not in the manual?
Questions and answers