DKS 2364-080 Quick Manual

WIRELESS REPEATER KIT
The wireless repeater kit extends the wireless communication range between an access control system and wireless tracker expansion board or
just between wireless tracker expansion boards. It gets installed between the wireless systems that are too far or obstructed from each other to
reliably communicate with each other. It will repeat a signal sent to it and relay that signal to the next wireless system. Multiple repeaters can be
used in the same communication line of tracker expansion boards. The approximate signal range is 500 ft direct-line-of-sight with no signal
interference.
Installation
7.75"
3.5"
3"
Antenna is REQUIRED.
(Included)
5"
1/2"
Conduit
1/2" thick wall PVC conduit recommended
Metal conduit may interfere with wireless signal.
Important Antenna Note:
GREATLY depending on individual setup (Antenna height
above the ground, background signal interference,
physical obstructions (trees, buildings etc.)).
Adverse weather (rain) CAN also affect antenna range.
Range testing is HIGHLY recommended
+
-
RF ID RF CHANNEL
4 4
1 6
RF LOST RF SYNC RF STRENGTH
2364-010
Power Transformer
(not supplied).
Antenna range WILL VARY
before FINAL installation.
POWER POWER ER
See back page.
DoorKing Part Number
2364-080
IMPORTANT:
Install the
repeater so the
antenna is in a
location that is
NOT surrounded
by metal and is
in free air as
high as possible
above the
ground.
Minumum 15 ft
above ground
recommended.