Glasdon Rebound Signmaster Installation Instructions

®
Rebound Signmaster
IMPORTANT NOTE: ENSURE ALL RELEVANT PERSONNEL READ THE POINTS LISTED BELOW
AND THAT A COPY IS PASSED ON TO STAFF INVOLVED WITH THE INSTALLATION.
SAFETY NOTE: Please refer to the 'Manual handling Operations Regulations 1992'
During the handling of the product and materials used for the installation.
PRODUCT COMPONENTS:
ITEM 1. Bollard
ITEM 2. Adjustable Concrete-in Fixing
ITEM 3. Spacer (M10 x 28 mm)
ITEM 4. Washer (M10 x 50 mm)
ITEM 5. Fixing Screw (M10 x 100)
INSTALLATION:
1) Check for buried services before starting installation.
2)
Prepare a hole 430mm x 430mm x 400mm deep.
3)
Fully assemble and tighten all four Concrete-in Fixings (item 2)
to the base of the bollard (item 1) as shown in the diagram A.
4)
If the depth is restricted to less than 400mm the fixing can be
adjusted by moving the bottom washer of item 2 up the
Concrete-in Fixings and cutting the bar to the desired length.
We would recommend using the same volume of concrete by
increasing the width of the hole accordingly.
5)
Place aggregate and support blocks in the base of the prepared
hole.
6)
Place the Concrete-in Fixing Assembly into the hole ensuring
that the fixings rest on the support blocks and that the bollard
is vertically level.
7)
Remove the bollard and fixing assembly and pour the concrete
mix into the prepared hole to the desired level.
8)
Ensure the bollard is orientated correctly with regard to the site
requirements. (i.e. Retro-Reflective Sign Faces and Amber
Patches).
9)
Fully insert the Concrete-in Fixing Assembly into the concrete
until the base of the bollard is flush with the top surface of the
concrete (see diagram B).
10)
If required the top of the bollard foot detail can be sunk flush
with the concrete/block paving to give a neat finish. DO NOT
concrete over the fixing screw heads as this will impair the
performance of the Rebound models and will prevent the
bollard being replaced.
11) Ensure the bollard remains vertically level during the concrete
setting period.
REPLACING YOUR BOLLARD
1)
Remove the four Fixing Screws with the 6mm Allen Key
provided (discard the Fixing Screws).
2)
Remove the existing bollard and replace with your new bollard
in the correct orientation aligning the holes in the bollard base
with the existing Anchor Rawl Plugs.
3)
Insert Spacer (item 3) into the four holes in the base of the
bollard.
4)
Position a Washer (item 4) onto the Fixing Screw (item 5) and
insert one into each of the four holes.
5)
Using the 6mm Allen Key provided, loosely tighten each of the
Fixing Screws, and then fully tighten to complete the
installation.
INSTALLATION INSTRUCTIONS
Adjustable Depth Concrete-in Fixing System
x 1
x 4
x 4
x 8
x 4
TM
TOOLS REQUIRED FOR INSTALLATION:
6 mm allen key (included within kit)
Equipment to excavate hole
Concrete Mix (Fast Setting)
Spirit Level
Diagram A
Diagram B
Bollard
ITEM 1
ITEM 5
ITEM 4
ITEM 3
ITEM 2
SIGN FACE
ITEM 1
CONCRETE
SUPPORT
BLOCK
GRAVEL
430mm (MIN WIDTH)