DeWalt DE0732 Instructions Manual page 15

Safety instructions
Always observe the safety regulations applicable
in your country to reduce the risk of fire,
electric shock and personal injury.
Read all of this manual carefully before operating
the attachment. Also refer to the manual of any
power tool that will be used with this attachment.
Save this manual for future reference.
General
1 Keep work area clean
Cluttered areas and benches can cause accidents.
2 Keep children away
Do not let children come into contact with the
tool or extension cord. Supervision is required for
those under 16 years of age.
3 Use appropriate tool
The intended use is described in this instruction
manual. Do not force small tools or attachments
to do the job of a heavy-duty tool. The tool will
do the job better and safer at the rate for which it
was intended.
Warning! The use of any accessory or
attachment or performance of any operation with
this tool, other than those recommended in this
instruction manual may present a risk of personal
injury.
Additional safety instructions for batteries
• Do not open or mutilate batteries for any reason.
• Do not expose batteries to water.
• Do not expose batteries to fire.
• Do not store batteries in locations where the
temperature may exceed 40 °C.
• Use only the correct size of batteries.
When replacing, do not mix old batteries with
new ones.
• Under extreme conditions, battery leakage may
occur. When you notice liquid leaking out,
proceed as follows:
- Carefully wipe the liquid off using a cloth.
Avoid skin or eye contact. Do not swallow.
- In case of skin or eye contact, rinse the liquid
off with clean flowing water for at least 10 minutes
and contact a doctor.
Fire hazard! Avoid short- circuiting the
contacts of a removed battery.
DE0732.P65
Package contents
The package contains:
1 Digital laser detector
1 Clamp
3 Batteries
1 Instruction manual
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your DE0732 digital laser detector has been
designed to extend the capabilities of your D
rotary laser. The detector helps locating the position
of a laser beam in bright light conditions or over long
distances. It produces both visual and audio signals
as the rotating laser beam crosses the detector.
The attachment can be used both indoor and outdoor
whenever it is difficult to locate the laser beam.
This attachment is intended to be used with a rotary
laser. It will not work with a stationary laser.
Fig. A
1 Power-on button
2 Audio signal volume button
3 Display
4 Beam detection window
5 Magnets
6 Battery compartment
7 Battery compartment cover
Assembly and adjustment
Replacing batteries (fig. A & B)
The attachment uses batteries of size AAA. The low-
battery sign (8) will appear on the display (3) to
indicate that the batteries need to be replaced (fig. B).
• Unscrew and remove the battery compartment
cover (7) (fig. A).
• Replace the batteries. Make sure the new
batteries are placed according to the orientation
as indicated.
• Re-install and close the battery compartment
cover.
15
E N G L I S H
Also refer to the manual of the tool to be
used with this attachment.
27-06-2001, 16:45
WALT
E
15