Cleaning & Maintenance - Nostalgia HKP200 Instructions And Recipes Manual

CLEANING & MAINTENANCE
1. Make sure appliance is unplugged and completely cooled before cleaning. Unplug
the outer plug to the outlet as well as the Kettle motor plug inside the Main Unit.
2. Use slightly damp, non-abrasive sponge, towel or cloth to wipe down the inside
and outside of Main Unit, then wipe with a non-abrasive towel to dry.
3. Remove the Pull Out Tray. Wash in warm soapy water with a non-
abrasive sponge or cloth. Dry thoroughly. Replace in main unit.
4. After Kettle motor has been unplugged and Kettle has completely
cooled, remove the Kettle from support brackets.
5. Take Kettle out of the Main Unit. After removing Kettle from
Main Unit, fill / of Kettle with hot, soapy water.
2
3
6. Let the Kettle sit for 15 – 20 minutes to cut the grease. (Time may vary – use
your own judgment depending on the amount of cleaning necessary.)
7. Empty water. If necessary, use the scrubber side of a
cleaning sponge to scrub inside of Kettle.
8. Rinse inside carefully and dry.
9. Wipe outside of Kettle with damp cloth and dry.
10. Reattach Kettle to Main Unit.
NOTE: To protect the motor plug from getting wet, never immerse the Kettle in
any liquid. Never place any parts in the dishwasher. Always wash by hand.
CHANGING THE BULB
The unit comes with a 20 watt light bulb installed to make the Marquee light up.
When the bulb goes out, you may change it. Use a regular light bulb up to 20 watts or
a compact fluorescent light bulb up to 20 watts for greater light intensity (a compact
fluorescent light bulb is the equivalent of 150 watts with a 20 watt output).
Follow the steps below to change the light bulb:
1. While unit is turned off and has cooled completely, unscrew the nine screws
underneath the Marquee using a Phillips head screwdriver. There are three
screws on the front underside of the Marquee, three on the right underside
of the Marquee and three on the left underside of the Marquee.
2. Lift top of Main Unit to expose the bulb.
3. Unscrew light bulb and replace with either a regular light bulb up to
20 watts or a compact fluorescent light bulb up to 20 watts.
4. Replace top of Main Unit and replace screws.
9