Page 1
Want to make your shop Highly Efficient, too? Reduce install mistakes and improve efficiency by transforming your shop with our 24volt System. With our 24volt PhxNRG MODULES, our 24volt PhxNRG BARS & 24volt Wing Span products, you only need 24volt Hanley Premium Power Supplies stocked in your shop. •...
Tape Measure Screwdriver Components: 1 ft whip Phoenix NRG Bar • Retrofit (RF) Connector is already screwed onto ends • Simply remove screw & cap for new construction signs • PhoenixNRG Bars come with a 1 ft whip 24v Power Supply...
Page 3
Phoenix NRG Bar This guide is designed to aid in the installation of HanleyLED’s Phoenix NRG Bar. Skilled trades people that are familiar with general construction, electrical, and sign installation techniques should do the installation. Licensed electricians should provide all installation and hook-up of both the primary and secondary input/outputs of the HanleyLED power supply.
Page 4
ALL PHOENIX NRG BAR SIZES Your Phoenix NRG bar is ready to go out of the package. Simply open the hinge and snap your bar into existing lamp sockets for retrofits, or screw directly into existing structure for new installs. NO PEELING AND STICKING OF MODULES REQUIRED!
(inch) between bars (inch) Lightbox size: 47” x 67” Phoenix NRG Bars Tested with 3/16” by HanleyLED 7328 white acrylic Power Supply Load Chart & Cascading (Phoenix NRG bars in a series) Information Guidelines Item Watts/Bar Power Supplies (24v)
- Please ensure that the output voltage of using power supply is DC (24±5%)V, and the rated power supply is recommended to underload by 20%. (HanleyLED “PPS5” and “PPSEM” Power Supplies can be loaded to 100% if absolutely needed with no effect to warranty)