Page 1
INSTALLER: DO NOT DISCARD THIS MANUAL - LEAVE FOR HO MEOWNER ELECTRIC FIREPLACE MODEL NO. OL-S1M WARNING! IF INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
Thank you and congratulations on your purchase of a OLMO fireplace. Table Of Contents IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the guarantee.
Installation Instructions General 1. Read all instructions before using the appliance. 16. This appliance has hot and arcing or sparking parts 2. This appliance is hot when in use. To avoid inside. Do not use it in areas where gasoline, paint, burns, do not let bare skin touch hot surfaces.
Electrical Connection WARNING: Electrical outlet wiring A 10 AMP,220 Volt, 50 Hz circ uit with a properly must comply with local building codes grounded outlet is required. Preferably, the fireplace and other applicable regulations to will be on a dedicated circuit as other appliances on reduce the risk of fire, electrical shock the same circuit may cause the circuit breaker to trip or and injury to persons.
Replacing the Light Bulbs This fireplace uses one or two clear 220Volt, 60 Watt, E-14 socket base light bulbs (small base, chandelier candle type). The 60 Watt bu lbs are located under the log set/ember bed. 1. Turn off the power switch and unplug the power cord. 2.
Operating Instruction Manual Operation There are three switches located at the right-hand While all upside of the three switches are pushed, the downside of the fireplace. way of control is changed to remote control. The power switch is the right one of the three switches. The downside of the power switch is for hand control and flame on, and the upside for remote control.