Summary of Contents for Dan's Comp Odyssey Elementary Stem
Page 1
Odyssey Elementary Stem Installation Tools Needed • Grease • Allen Wrenches • Open/Closed end wrench • Adjustable wrench Note: Tools needed will vary depending on the style of headset compression cap and bolt being used. Removing the Handlebars • Loosen and remove the clamping bolts holding the face plate on the top or front of the stem.
Page 2
Odyssey Elementary Stem Installation • Loosen and remove the headset compression bolt and cap. Note: Headset compression bolts and caps vary. Some styles require an allen wrench, some require a ratchet and some require a closed/open end wrench or an adjustable wrench.
Page 3
Odyssey Elementary Stem Installation Installing the Wedges • Slide the handlebar into the stem body. • With the curved surface facing down, slide the handlebar wedge into the stem body and place it on the handlebars. • Thread the lock bolt into the threaded wedge.
Page 4
Odyssey Elementary Stem Installation Add or remove headset spacers • Line up the stem along side of the steerer tube. • You should have approximately ¼ of an inch from the top of the fork steerer tube and the top of the stem opening.
Page 5
Odyssey Elementary Stem Installation Aligning the Stem • Looking down over the handlebars and stem, align the stem with the front tire. The stem should be parallel to the tire. • Use the knurling (the rough area) on the handlebars to help center them in the stem.