Summary of Contents for Bibby Sterilin Electrothermal MC5
Page 1
Method for connecting a Heating Tape / cord to an MC5 / MC227/ MC228x1 Controller. ATTENTION: INSTALLATION MUST BE UNDERTAKEN BY A COMPETENT ELECTRICIAN. To connect a Heating Tape to an MC controller you will require a connecting lead set. This sheet details a process for assembling a suitable lead set.
Page 2
Unscrew and remove the cable clamp bridge found with in the IEC plug. Reserve for use later. Feed the wires through the rubber grommet of the IEC plug. Connect the wires to the terminals as illustrated. Ensure the plug terminal screws are fully tight and the cable is secure.
Page 3
Fasten the wires from the IEC plug to the heating tape terminal block. Note: There is no positive (+) or negative (-) polarity. Warning: On heating tapes with 3 wires the Earth wire from the IEC plug must be connected to the earth position in the terminal block. On the terminal case type refit the cable bridge clamp before closing and fastening the case.