Advertisement
A
Start
Here
E
F
ASSEMBLY INSTRUCTIONS
1. Attach the upper frame to the grass catcher bag
as follows.
a. Lay the grass bag so the black plastic side is to
the bottom.
b. Insert the long end of the upper frame into the
cloth channel in the grass bag, starting at the
point shown in figure A.
c. Feed all the material onto the long side of the
frame. See figure B.
d. Then insert the long end of the frame inside the
bag as you work the bag around the frame.
e. Insert the other end of the frame inside the
bag. See figure C.
2. Place one tube support inside the grass bag.
Insert one end of the upper frame into the tube
support. Tap on with a soft hammer or mallet.
Attach the other tube support in the same man-
ner. See figure D.
3. Slide the ends of the lower frame assembly into
the tube supports as shown in figure E. Tap on
with a soft hammer or mallet if necessary.
4. Secure the bag to lower frame assembly as
shown in figure F by working the plastic channels
on bag over frame, starting with the bottom edge.
5. Place belleville washer onto self-tapping screw
(crowned side of washer goes against the head of
screw). Place screw through eyelet in grass bag.
Secure to lower frame as shown in illustration on
reverse side.
SERVICE DEPARTMENT
B
G
For Replacement Parts, Contact:
•
P.O. BOX 368022
C
Side Discharge
H
"3-in-1" Mowers
Mowers
Tabs
Grass Bag
Hook
6. Close the top of the bag by stretching the loose
material over the end of the frame.
WARNING: Never operate the mower with
the bag open.
TO ATTACH GRASS CATCHER TO MOWER
Side Discharge Mowers:
Raise the chute deflector on your mower. Slip the two
outside tabs on the grass catcher frame underneath
the hinge pin on the chute deflector as shown in figure
G. Release the chute deflector to lock the grass
catcher in position.
"3-in-1" Mowers:
Place the grass bag hook in position against the grass
catcher frame. Secure with 5/8" long hex bolt, lock
washer and hex nut. See figure H. Tighten securely.
Lift the mulching plug on your mower. Slide the grass
bag into position so the grass bag hook is inside the
two hooks on the mulching plug adapter plate. Lower
the mulching plug into operating position. See figure I.
TO REMOVE GRASS CATCHER
Lift the chute deflector (or mulching plug), and remove
grass catcher from the adapter plate. Carefully lower
the chute deflector (or mulching plug) into operating
position.
Empty the grass through the top opening on the grass
catcher. Be certain to close bag before reattaching to
mower.
•
CLEVELAND, OHIO 44136-9722
D
I
"3-in-1" Mowers
Grass
Hooks
Bag
Hook
Advertisement
