Connecting To Yours; Eismic Edge Sound Card - Philips PSC705/05 User Manual

Connecting to Your Seismic Edge Sound Card
Speakers
Your Seismic Edge card can be configured as either a 5.1 channel analog output or 4 channel analog output
and S/PDIF Output depending on the Output Mode selected within the Settings Tab (see Settings Tab
section in this manual). When 5.1speaker mode is selected (default), the S/PDIF Out is disabled (grayed out
on the control panel).
Headphone, 2 Speaker and 4 Speaker Connections
Connect your front speakers or headphones into the FRONT OUT stereo jack on the end bracket. Connect
your rear/surround speakers to the REAR OUT stereo jack on the end bracket.
5.1 Speaker Mode
Connect your center/LFE speakers into the Cen/LFE or S/PDIF Out stereo jack on the end bracket.
S/PDIF Out Mode (Headphone, 2 or 4 speaker mode only)
To utilize the S/PDIF Out (Sony Philips Digital Interface Format) feature of your Seismic Edge card, insert a
1/8" stereo or mono plug to dual or single RCA plug adapter cable (not included) into the Cen/LFE or
S/PDIF Out stereo jack on the end bracket. The S/PDIF Output can be connected to digital speakers, an
AC-3 or DTS decoder, receiver or other device with an S/PDIF input. Note: If using a stereo cable, S/PDIF
Out will come from the left jack.
S/PDIF
To connect digital speakers, an AC3 or DTS decoder, receiver or other device with an S/PDIF Out of the
sound card plug it into the S/PDIF jack on the end bracket
Line In, Mic In and MIDI/Joystick
External analog stereo sources with line level output can be connected to light blue 3.5mm stereo jack at
the top of the sound card bracket. A microphone can be connected to the pink 3.5mm mono jack. An
analog or digital joystick and/or MIDI devices can be connected to the large connector at the bottom of the
bracket.
Internal Connections
Connectors for three line level analog inputs (Aux In, TAD, Analog CD In) are provided along the top of the
sound card as indicated in the picture on page 11. Use the 4 pin CD audio cable to connect the analog
audio output of you internal CD or DVD drive to the sound card "Analog CD In" connector.
Replace computer cover and reconnect the power cable, monitor, and other
devices.
13