Advertisement
ASSEMBLY AND MOUNTING (continued) :
5. Loosely assemble the dual U-bolt mounting bracket onto the crossarms as shown in Figure 3.
6. Lift the antenna into position, hold it upright and slide the U-bolt assembly onto the mast (1.50 to 2.00 in.
Dia Max).
7. Orient the antenna in the desired direction and tighten the hex nuts on the U-bolts sufficiently to support the
antenna.
8. Attach cable (RG-6/U recommended) to down lead.
9. Rotate the antenna until maximum signal strength is received, then fully tighten the hex nuts on the U-bolt
assembly.
MOUNTING PLATE
U-BOLT
MAST (1.50 to 2.00 in O.D. Max)
Figure 3
U-BOLT MOUNTING BRACKET
LOCKWASHER
HEX NUT
ANTENNA CROSSARM
Brantford, Ont., Can., N3T 5L8
www.wadeantenna.com
29 Sharp Rd,
Advertisement
