SUPREME Diamond Manual

SUPREME Diamond Manual

Advertisement

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Diamond and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for SUPREME Diamond

  • Page 2 TABLE OF CONTENTS Warranty……………………………………………………………………………………...3 Technical Specifications………………………………………………………………..3 Important Safety Instructions……………………………………………………….4 Unpacking/ Standard Accessories………………………………………………...4 Installation……………………………………………………………………………………5 Operation …………………………………………………………………………………….7 Maintenance………………………………………………………………………………..7...
  • Page 3 The Supreme Comprehensive Hand Dryer Warranty—36 Month Warranty 36 month warranty on all operating parts against the defective materials and faulty workmanship for a period of 36 months from date of sale, subject to it being installed, maintained and used in accordance with the manufacturers instructions.
  • Page 4 WARNING - TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: • Use this unit only in the manner intended by the manufacturer. Manufacturer is not responsible for damage caused by misuse or defective installations. •...
  • Page 5 CAUTION • Make sure power supply is switched off. • All electrical installation and repair work should be carried out by a qualified person in accordance with current local codes or regulations. • Check that the electrical supply corresponds to that shown on the rating plate. If the unit is connected to any electrical supply other than stated on the rating plate of the unit, permanent damage or unsafe operation of the unit may result.
  • Page 6 2. POSITIONING • 2.1 Mark the location on the wall with a pencil. Use the drilling template to mark the locations for the four fixing points. • 2.2 Pre-drill the wall in the marked locations using a 5/16 (8mm) drill, inset the plastic anchors and tap flush to the wall.
  • Page 7 Non touch operation. Shake excess water from hands Place hands under the outlet to start operation. Slowly move hands back and forth through the hand dryer. Sensor has blue light assist. Stops automatically after hands are removed. If there is an electrical or motor problem a blue LED will blink when hands are placed under sensor.

This manual is also suitable for:

Diamond-v

Table of Contents