PumpSpy Smart Outlet Setup Instructions

SMART OUTLET SETUP INSTRUCTIONS
2.
1.
PumpSpy
4.
3.
5.
8.
7.
RED LED
Cannot connect to Internet,
or High Water Alarm
Setting up your PumpSpy Sump Pump Smart Outlet
very easy and only takes a few minutes. You should setup your outlet
at a convenient location in your home and move it to your sump
pump later. Don't worry, the Smart Outlet will remember your
settings when you unplug it.
STEP 1: Download and Install the PumpSpy App from
the App Store.
STEP 2: Open the app and create a new PumpSpy Account.
• After entering your info, press Done.
• Press the home button on your Apple device.
STEP 3: Plug in the PumpSpy Smart Outlet.
• Plug the Smart Outlet into any AC outlet.
• The LED ring will light up and turn yellow (setup mode).
• If the LED ring is not yellow, gently press and hold the button with the
PumpSpy logo. The unit will turn yellow/enter setup mode after 3 seconds.
STEP 4: Connect to the PumpSpy Smart Outlet
• On your Apple device, open Settings.
• Select WiFi.
• Select the WiFi network named "PumpSpy. "
6.
• Press the home button on your Apple device.
STEP 5: Setup the PumpSpy Smart Outlet
• Open the PumpSpy app.
• The PumpSpy app will ask your permission to send you notifications. Click OK.
• Select your WiFi network from the list of available networks.
• Enter the password for the selected WiFi network and press Done.
• The LED ring will turn green. A Green ring means the outlet is connected to
PumpSpy and is ready for use.
• A Success message will be displayed once connected. Press OK.
• Continue the setup process on the app by entering the location
of the Smart Outlet.
STEP 6: Enter Alert Contacts
• On the PumpSpy App, select Contacts.
• Following the onscreen prompts, enter cell phone numbers and/or email
addresses that should receive PumpSpy alerts.
STEP 7: Connect Your Sump Pump to the Smart Outlet
( Refer to Owner's Manual )
STEP 8: Install the High Water Sensor ( Refer to Owner's Manual )
/
WATCHING 24 7
YOUR SUMP PUMP SYSTEM
is