When battery is installed:
•
To switch on the Presenter, push the USB receiver into the
Presenter and then remove the USB receiver from it.
•
To switch off the Presenter, push the USB receiver to the end.
4
Auto-connect
1 Ensure that your notebook is switched on and active.
2 Ensure that your Presenter is switched on.
•
If the USB receiver is inserted into your Presenter, release the
USB receiver from your Presenter (Fig. 3).
3 Plug the USB receiver into a USB host on your notebook.
Auto-connection starts.
»
If connection is successful, the LED indicator indicates 1 long
»
blink.
If connection fails, the LED indicator indicates 2 long blinks.
»
The LED blinks upon ever y successful communication
»
between the Presenter and the USB receiver.
E Tip
•
After use, inser t the USB receiver into your Presenter for
storage (Fig. 4).
•
Upon the first installation on Mac,
may appear and prompt that the keyboard cannot be
identified. Just click Continue to finish the installation, and
then the Presenter will work accordingly.
5
Troubleshooting
No transmission.
Light on your Presenter
blinks 3 times.
Keyboard Set Assistant
Ensure that you use the Presenter
within effective range.
Replace battery on the Presenter.