Mr. Heater MHVFGH30LPT Operating Instructions And Owner's Manual page 7

Figure 5
Removing Front Panel of Heater
1. Remove (4) screws total there are (2) screws on
either side of the heater. (Figure 6)
2. Pull the front panel and back panel apart.
(2) Screws
Figure 6
Attaching Mounting Bracket to Wall
Use holes on each end of mounting bracket to attach
bracket to wall. These holes are 16 inches apart. Attach
mounting bracket to wall in one of two following ways.
1. Attach to wall studs
2. Attach to wall anchor
Attaching to Wall Stud:
This way is the best providing the strongest mounting in
wood frame houses.
Attaching to Wall Anchor:
This way allows you to attach mounting bracket to hollow
walls (wall areas between studs) or to solid walls (concrete
or masonry).
Decide which way best suits your needs. Either method will
provide a secure hold for the mounting bracket.
1. Tape mounting bracket to wall where heater will
be located. Make sure mounting bracket is level.
For wall stud mounting locate one end of the
mounting bracket over a wall stud.
WARNING: Maintain minimum clearances shown in fig-
ure 7. If you can, provide greater clearances from the floor
and joining wall.
2. Mark screw locations on wall (see figure 7).
3. Remove tape and mount bracket from wall.
Unvented Liquid Propane Fired Room Heater
Mounting
Bracket
Attaching to Wall Stud:
For attaching mounting bracket to wall studs
(2) Screws
Attaching to Wall using Anchor:
For attaching mounting bracket to hollow walls (wall areas
between studs) or solid walls (concrete or masonry)
Placing Heater on Mounting Bracket
7
Installation Instructions and Owner's Manual
See clearance
specs on Pg 3
16" (Lg)
12-9/64" (Sm)
Mark mounting hole locations
and drill holes where indicated.
Allow for minimum clearances
Figure 7
1. Drill holes at marked locations using 9/64" drill bit.
2. Place mounting bracket onto wall. Line up holes on
each end of bracket with hole drilled in wall.
3. Insert mounting screws through bracket and into
wall studs.
4. Tighten screws until mounting bracket is firmly
fastened to wall studs.
Note: Wall anchors, mounting screws, and spacer are in
hardware package. The hardware package is provided
with heater.
1. Drill holes at marked locations using 5/16" drill bit.
For solid walls (concrete or masonry), drill at least
1" deep.
2. Fold wall anchor as shown in figure 8.
Figure 8.
3. Insert wall anchor (wings first) into hole. Tap
anchor flush to wall.
4. For thin walls (1/2" or less) insert red key into wall
anchor.
5. Place mounting bracket onto wall. Line up holes on
each end of bracket with wall anchors.
6. Insert mounting screws through bracket and into
wall anchors.
7. Tighten screws until mounting bracket is firmly
fastened to wall.
1. Locate two horizontal slots on back pane of heater
(see figure 9).
18" Min.