Advertisement
Install the Transformer
1A
SCREW
CANOPY
1
Separate the mounting plate from the transformer by
removing the two screws.
1B
#8-32 SCREW
2
Attach the mounting plate to the electrical box using
the two #8-32 screws provided.
1C
5
3
Connect the mounting plate ground wire to a suitable
ground in accordance with local electrical codes.
4
Connect the white transformer wire to the neutral
power line wire with a wire nut.
5
Connect the black transformer wire to the hot power
line wire with a wire nut.
6
Place all wires and wire nut connections inside the
electrical box.
MOUNTING PLATE
SCREW
#8-32 SCREW
3
4
1D
7
Reattach the transformer to the mounting plate by
securing it with the two screws.
Connect the Transformer Wires
Directly to Kable Lite Cables
2A
INSULATED KABLE
LITE CABLE
1
When using insulated Kable Lite cables, remove ½" of
the insulation from each cable (where the power feed
connector is going to be mounted) with a sharp knife.
Make sure not to cut or nick the cable.
2B
POWER FEED WIRE
#6-32 SET SCREW
KABLE LITE CABLE
2
Unscrew the #10-32 slotted head set screw from the tip
of the power feed connectors with a screwdriver. Place
the power feed connectors one onto each Kable Lite
cable and tighten the #10-32 slotted set screw on the
tip with the screwdriver.
2
½"
1
KNIFE
POWER FEED
CONNECTOR
#10-32 SLOTTED
SET SCREW
2
Advertisement
